3. Hold the door glass securely in place with oneREPLACING THE OVEN LIGHT BULB
hand before removing the screws completely with
the other hand.The type of bulb required is a 300°C 25 watt small
Edison Screw. Part number 572 491 5431-00/1
4. Using both hands, gently tilt the top of the door(Available through Service Force Centres).
glass towards you, lift slightly to disengage the
locators from the two bottom brackets.
CAUTION:Disconnect the appliance from the
5. Clean the outer and inner glass using hot soapyelectricity supply before replacing the bulb.
water or Hob Brite cleaner may be used. DO NOT
try to clean the aluminium foil which is inside theOpen the door and remove the shelves to enable
door. The foil is there to help keep the door cool,easy access to the oven light assembly. Insert a flat
blade screwdriver between the oven side and glass
if it is damaged it will not work. Ensure that all
parts are well rinsed and thoroughly dried beforewhich covers the bulb.
attempting to replace the outer door.
Support the glass with your hand and prise out
sufficiently to release the glass cover. Unscrew the
TO REPLACE THE OUTER GLASSbulb in an anticlockwise direction until it is possible to
remove the bulb with ease.
1. Holding the oven glass with both hands, gently
place the locators into the holes of the brackets atFit the new bulb by turning in a clockwise direction
the bottom of the oven door.until it is secure. Ensuring the indent to the flange is
pointing to the rear of the oven, replace the glass by
2. Push the top of the oven glass towards the ovenpushing it firmly into the hole to cover the bulb
door, ensuring the screw location holes line up.assembly.
3. Hold the glass in place with one hand and insertReplace the shelves. Restore the electricity supply
the cross head screws into the location holes withand adjust the time of day and clock as necessary.
the other hand. Give the screws one turn to
ensure the glass is secure.
4. Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
Do not attempt to use the oven without the glass
being in place.
If the door glass panel becomes chipped or
has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
Please contact your local Service Force
Centre who will be pleased to advise
further.
TO CLEAN THE INNER GLASS DOOR
PANELS
Clean the inner glass door panels using a soft cloth
and hot water to which a little washing up liquid has
been added. If the inner panel is heavily soiled, Hob
Brite may be used. Do not use abrasive cleaning
materials on the door glass. Ensure that all parts are
well rinsed and thoroughly dried before attempting to
replace the glass.
27 |